Router Connection
Connect the camera to the network router by one of two methods
Ethernet Cable
Plug Ethernet cable into camera and port on customer’s router then wait 2 minutes
WIFI WPS protected setup mode
1. Insert paperclip into hole and hold button for 5 seconds, blue LED flashes
2. Press and release WPS button on router or enable WPS mode in router programming
3. Wait 2 minutes, if successful camera LED turns green, if failure LED turns red
1. From the customer website press Video
2. Press Settings
3. Press Add Video Device
4. If the camera is found press Name then enter the camera name then press INSTALL
5. Alarm.com sends configuration data to the camera, this may take several minutes
6. When finished press Live View to view camera image
7. If connected by Ethernet cable and needing to configure WiFi press SETTINGS
8. Select camera from drop-down box
9. Scroll down and select Wireless Network
10. Press SCAN
11. Select wireless network
12. Enter WiFi encryption then press NEXT
13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot